Pass thread over the top of tension control between the two silver discs. Pass thread upward through the eyelet of the thread guide 1. Spring must be in place before installing the bobbin. The thread should flow from the top right of the bobbin. 7Ī) Pass the threader through to the last stitch.ī) Put the thread into the threader and pull out about 1 inch.ĭ) Pull the thread tight to finish the knot Turn to the back side of the cloth and guide the reserved 3 inches of thread according to the following directions and corresponding drawings: Fig. The reserved 3 inches thread shall be in the backside of the cloth, if not, please turn to the backside of the cloth, and then pull the thread out to the backside. If the reserved 3 inches thread is in the front side of the cloth, then pull the thread, the seam will unravel.Ģ. Lift the fastening plate and take off the cloth. When finished sewing, raise the needle arm to the highest position by turning the rotary wheel, then use the back of a seam ripper or scissors to pull the thread out about 3 inches. You can follow the centerline on the fastening plate to ensure straight stitching. Be careful not to pull the material through the appliance too quickly. Use your left hand to hold the cloth and to control the direction and speed as you pull it through the appliance. Turn the appliance on by sliding the on/off switch forward with the thumb. Place thumb by the on/off switch while other fingers support the bottom of the appliance. Hold the appliance with your right hand. If the needle needs to be threaded, please refer to the “HOW TO THREAD” section. Pull at least 2 inches of thread through the needle, from back to front, prior to starting to sew. Place cloth underneath the fastening plate. Lift the fastening plate, making sure not to push down on the needle arm (the arm can still be moved manually even when the appliance is in the locked position). 
Note: the rotary wheel can be turned in either direction. Raise the needle arm to the highest position by turning the rotary wheel.
Make sure the appliance is in the OFF position.Use care when working with needles to avoid injury. Keep the machine in a dry and ventilated place.Whenever the appliance is not in use make sure it is switched off and the batteries are taken out /unplugged from the power supply.Never use the appliance if damaged in any way.Do not use the appliance for other than intended use.This appliance is not designed for commercial use.Switch off the appliance and take off the batteries/ unplug the appliance before carrying out maintenance.Never leave the appliance unattended during use.Never attempt to open the housing of the appliance, or to repair the appliance yourself.Always keep your hands away from the needle, bobbin, rotary wheel when the appliance is running.Never run the machine when there’s a thread in the needle, but no fabric on the machine.The supply terminals are not to be short-circuited.If the appliance is to be stored unused for a long period, the batteries should be removed.Exhausted batteries are to be removed from the appliance and safely disposed of.Batteries are to be inserted with the correct polarity.
Different types of batteries or new and used batteries are not to be mixed.Non-rechargeable batteries are not to be recharged.
Switch off or unplug the appliance when leaving it unattended. This appliance must only be supplied at safety extra-low voltage corresponding to the marking on the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children shall not play with the appliance. This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. The manufacturer/importer accepts no liability for damages caused by failure to follow the manual, negligent use, or use not in accordance with the requirements of this manual. In case of damage caused by the user failing to follow the instructions in this manual, the warranty will be void. If you give or transfer this appliance to someone else make sure to also include this manual. Handheld smart stitch instruction manual manual#
Make sure to keep this manual in a safe place. Before use make sure to read all of the below instructions in order to avoid injury or damage, and to get the best results from the appliance.
0 kommentar(er)
